FVR1C1BM1-M Comnet Digitally Encoded Video Receiver and Contact Closurer, mm, 1 fiber

The ComNet FVR1C1B receives one channel of video over one optical fiber utilizing 8-Bit digital decoding for high-quality video and contact closure transmission. These environmentally hardened units are ideal for use in unconditioned roadside or out-of-plant installations. This module is universally compatible with major CCTV camera manufacturers. Bi-color (Red/Green) LED indicators are provided for rapidly ascertaining equipment operating status. These units are interchangeable between stand-alone or card mount configurations.

Specifications

Video

• Video - 1 volt pk-pk (75 ohms)
• Overload - >1.5V pk-pk
• Video Channels - 1
• Bandwidth (minimum) - 10 Hz - 6.5 MHz
• Differential Gain - <2%
• Differential Phase - <0.7˚
• Tilt - <1%
• Signal-to-Noise Ratio (SNR) - >60 dB @ Maximum Optical Loss Budget
• Max. RG-59 COAX Distance - 100m (300ft) Camera to Fiber Optic Module to maintain 6Mhz Bandwidth

Contact

• Contact Interface - Response Time - 0.5 msec
• Output - SPST Relay, 0.5 A Contact Rating - normally open
• Wavelength - 1310 nm, Multimode & Single Mode
• Number of Fiber - 1

Led Indicator

• Contact - Video

Connectors

• Optical - ST
• Power - Terminal Block
• Video - BNC (Gold Plated Center-Pin)

Electrical & Mechanical

• Power Surface Mount - 8-15 VDC @ 2W
• Rack Mount - From Rack
• Number of Rack Slots - 1
• Current Protection - Automatic Resettable Solid-State Current Limiters
• Circuit Board - Meets IPC Standard
• Size (in./cm) (LxWxH) - 6.1 x 5.3 x 1.1 in., (15.5 x 13.5 x 2.8 cm)
• Shipping Weight - <2 lb./0.9 kg

Environmental

• MTBF - >100,000 hours
• Operating Temp - -40˚ C to +75˚ C
• Storage Temp - -40˚ C to +85˚ C
• Relative Humidity - 0% to 95% (non-condensing)

FVR1C1BM1-M Specifications PDF

FVR1C1BM1-M Manual