FS-1000E TAKEX 33' Ultraviolet Flame Sensor

FLAME DETECTION AT 33ft. (10m) AHEAD! SUPER HIGH SENSITIVITY IN A SMART DESIGN.

Flame sensor FS-1000E quickly detects ultraviolet rays contained in flames and activates a built-in alarm sound plus an open collector output.

POWER SUPPLY

The FS-1000E can be powerd from either type-3 alkaline battery ×2 pcs, or an external power source 9~30VDC depending on the application.
Optional power source can be from a long life lithium battery

EXTERNAL OUTPUT TO A SECURITY SYSTEM

Equipped with a form A (N/O) open collector output, FS-1000E can be connected to a security control panel. Alternatively the output signal can be used to initiate a warning device e. g. bell, siren etc., when used with an external DC power supply

OPERATION SET-UP BY DETECTION TIMER

The alarm will be activated only when the sensor detects a flame (ultraviolet rays) in accordance with the detection timer. The 4 following detection times are selectable by a slide switch located on the sensor body.
1sec. 6sec. 15sec. 30sec.

OTHER FUNCTIONS

- The internal alarm sounder output is greater than 80dB at 3.3ft. (1m) in front of the sensor. The internal sounder can be disconnected by cutting a jumper wire if required when using an external DC power supply.
- Compact design enables FS-1000E to be installed at any location. Easy separation of the sensor unit from the base simplifies installation and maintenance.
- Low battery
When using a battery power source, low battery condition is annunciated by an internal buzzer and external LED.
- Power up
When power is turned on, an alarm sound is activated. If no alarm sound is activated, check the power source.

Specifications

• Detection system - Ultraviolet rays detection
  (Detected wave length 180~260nm)
• Coverage - Distance:
  33ft. (10m) (2.76"(7cm) lighter flame, in front)
  Angle:
  Approx. 120° conically
• Supply voltage - Type-AA alkaline battery (LR6) 2pcs / DC3V
  External wiring DC9 ～ 30V (Polarized)
• Current consumption - Stand by: 50μA Max. when battery power supply, 5mA Max. when external power supply
  Alarm: 50mA Max. when buzzer sounds
• Alarm output - NPN open collector output
  (Useful as an output with voltage when external power is used)
  30V (DC) 50mA, off-delay 10sec. continuous output
• LED indicator - Indication: Red LED
  LED Alarm: Flashing every 0.2sec. during off-delay approx. 10sec.
  Low battery: Light on 0.1sec. every approx. 5sec.
• Buzzer - Alarm: Sounds intermittently every 0.2sec. during off-delay 10sec.
  Low battery: Sound 0.1sec. intermittently every approx, 5sec.
  Volume: 80dB or more 3.3ft. (1m) ahead
  (Silent setting is available by cutting internal jumper line)
• Sensitivity adjustment - Detection sensitivity (H[100%], L[50%])
  Detection timer (1sec., 6sec., 15sec., 30sec.,)
• Mounting position - Indoor (Ceiling or wall mount)
• Wiring - Terminals
• Weight - Approx. 7oz (200g) including battery (accessory) 1.8oz (50g)
• Appearance - ABS resin (white)
• Ambient temperature - +14°F to +140°F (-10°C to +60°C) without condensation
  Battery performance may decrease under +32°F (0°C) or beyond +104°F (+40°C)