PR-11BE TAKEX Indoor/Outdoor Reflective Beam Sensor – 11M

PHOTOELECTRIC BEAM SENSOR

This is a reflective infrared sensor that can be installed with one-side wiring saves installation time and cost

EASY INSTALLATION

As wiring is needed only on the sensor unit (one side), you can use it in places where it is dicult to wire on both sides. One-side wiring reduces time and cost of installation significantly.

FOR INDOOR AND OUTDOOR APPLICATIONS

This sensor can be used both indoor and outdoor. 2 types of attenuation sheets (for indoor and outdoor) are attached.

EASY BEAM ALIGNMENT

Beam alignment can be adjusted on the sensor unit side only by utilizing viewfinder, attached attenuation sheets and alarm LED.

AMBIENT LIGHT IMMUNITY

The sensor has a unique ambient light compensation circuit and special filters to obtain a strong immunity to ambient light such as sunlight, vehicle headlights and mercury light.

FLEXIBLE PROTECTION AREA SETTING

Using the adjustments, the lens can move horizontally (±90 degrees) and vertically (±10 degrees) allowing the unit to work in all directions.

RESPONSE TIME ADJUSTMENT

Response time can be adjusted by the response time adjustment potentiometer. (0.05~0.7 sec.)

EASY OPERATION CHECK

Operation check can be done quickly with alarm LED (red).

OPTION ACCESSORIES

・L bracket (BL-11) : Wall bracket for mounting reflector
・Angle adjustment bracket (BL-1130) : Wall bracket for mounting sensor and reflector
・Pole attachment (BP-60A) : Pole mounting attachment for sensor unit

Specifications

• Type - Reflective
• Detection system - Near infrared beam interruption system. (reflective)
• Detection distance - Outdoor 3.3 to 36' (1 to 11m)
  Indoor 3.3 to 49' (1 to 15m)
• Supply voltage - 10.5V to 30V DC (Non-polarity)
• Current consumption - 55mA or less
• Alarm output - Dry contact relay from N/O-N/C
  Contact capacity: 30V (AC/DC) 0.5A or less
  Relay operation: Interruption time (minimum 2 seconds)
• Tamper output - Dry contact relay 1b (N/C)
  Action: Activated when cover is detached
  Contact capacity: 30V (AC/DC) 0.5A or less
• Response time - 0.05sec to 0.7sec. (Adjustable by potentiometer)
• Frequency Selection - Single Channel
• LED indicator - Red LED ON: when an alarm is initiated
  Red LED ON: when beam is attenuated
• Functions - Monitor output
• Mounting position - Outdoor/Indoor
• Wiring - Terminals
• Weight - Sensor: 15oz (430g) Reflector: 17oz (490g)
• Appearance - Sensor: PC resin (wine red)
  Reflector: acrylic resin (clear), AES resin (black)
• Ambient temperature - -13°F to +140°F (-25°C to +60°C)
• IP Rating - IP54