SWX-SST SimpleWorx Sunrise Sunset Timer - Black

The Sunrise Sunset Timer (SST) features an astronomical clock which is capable of turning landscape transformers and other 120VAC devices ON and OFF based on one of the ten preset daily schedules. The SST is also remotely controllable, with digital SPC (Simple Powerline Communication) commands received, by eight different SimpleWorx Transmitters. It also has a manual override button for local control of the load.

Specifications

Electrical

• Power Requirements - Primary: 120 Volts AC, 50/60Hz Single Phase
• Neutral Wire - Required
• Channels - One
• Switch Load Types - Standard inductive loads up to 15A and incandescent loads up to 800W
• Relay Lifetime: - 100,000 on/off operations at full electronic ballast load
• Max Load - 15 Amps @ 120V AC 50/60 Hz
• Standby Power Consumption - < .8 Watts
• Environmental Conditions - Outdoor Water Resistant Use Only, Temperature: -40° to 140°F (-40° to 60°C), Humidity: 10% to 90% RH (non-condensing)
• Certifications - Safety tested for USA and Canada ETL tested to UL508, UL-508-2010 CSA C22.2 #14-2010

Operation

• Status LED Modes - Red = Operation Mode, Blinking Green = Link Mode, Blinking Red = In Programming Mode, Blinking Orange = In Re-Schedule Mode, Slowly Blinking Red = Temperature Protection is Activated
• During Power outage - Retains all settings in Non-volatile EERPOM

Mechanical

• Set Button - Button
• Mounting - 3-pin grounded outlet
• Dimensions - Length: 3.0 in Width: 2.0 in Depth: 1.55 in
• Weight - .3 oz.
• Warranty - 10 years
• US Patent No. - 6,734,784; 6,784,790; 7,265,654; 7,688,183. U.S. and foreign patents may be pending.

Modes Descriptions

• Normal - Power Is applied to device
• Link - Press and Hold Button for >6 sec.
• Link Exit - Tap while in Link Mode
• Programming Mode - 3 taps while in LINK Mode
• Programming Mode Exit - Hold Button for 3 sec. while in PROGRAMMING Mode
• Review Mode - 3 taps while in NORMAL Mode
• Re-Schedule Mode - 4 taps while in LINK Mode
• Clock Review Mode - 8 taps while in NORMAL MODE
• Signal Strength Mode - 6 taps while in NORMAL Mode
• Noise Strength Mode - 7 taps while in NORMAL Mode
• Factory Default - 10 taps while in LINK Mode

Led Indicator Status

• Red - Normal Mode Power Applied
• Blinking Red - In Programming Mode
• Blinking Green - Link Mode
• Blinking Orange - In Re-Schedule Mode
• Solid Green - Transmitting a SPC Message
• Dark/Green - Test Mode
• Pulses Green 1-16X - Same Phase/ Signal Strength Display Mode of a Receiver
• Pulses Red 1-16X - Opposite Phase / Signal Strength Display Mode of a Receiver
• Pulses Orange 1-16x - Relative Noise Strength at Receiver
• Blinks Red 10x - Indicates that device has been factory defaulted
• Slowly Blinking Red - Temperature Protection is Activated

Schedules - On OFF

• Schedule #1: - SUNRISE SUNSET
• Schedule #2: - SUNSET –30 Min SUNRISE +30 Min
• Schedule #3: - SUNSET MIDNIGHT
• Schedule #4: - SUNSET 10:00 PM
• Schedule #5: - SUNSET 2:00 AM
• Schedule #6: - SUNSET MIDNIGHT, SUNRISE -30 Min SUNRISE
• Schedule #7: - SUNSET MIDNIGHT, SUNRISE -60 Min SUNRISE
• Schedule #8: - SUNSET MIDNIGHT, 6:00 AM SUNRISE +30 Min
• Schedule #9: - SUNSET 10:00 PM, SUNRISE -60 Min SUNRISE +30 Min
• Schedule #10: - SUNSET 10:00 PM, SUNRISE-30 Min SUNRISE +30 Min

SWX-SST Specifications PDF