SWX-FMR-AC SimpleWorx Fixture Module Relay - Black

The FMR module was designed to be flexible enough to control almost any lighting or motor load, which may not have a direct connection to an existing switch or a switch without a neutral wire. The FMR switches line voltage in response to the on or off signals coming from its linked transmitter.

Specifications

Electrical

• Power Requirements - Primary: 120 Volts AC, 50/60Hz Single Phase
• Neutral Wire - Required
• Channels - One
• Switch Load Types - Incansdescent,Fluorescent, Ballast, Induction, LED, Motor
• Relay Lifetime: - 100,000 on/off operations at full electronic ballast load
• Connections/Power Wire 14 AWG gauge 105 C insulation, Black – Hot/Line, White – Neutral, Red – Load
• Standby Power Consumption - < .8 Watts
• Load Type - Relay on and off
• Maximum load - 20Amps @ 120V AC 50/60 Hz
• Environmental Conditions - Indoor Use Only, Temperature: -40° to 140°F (-40° to 60°C), Humidity: 10% to 90% RH (non-condensing)
• Certifications - Safety tested for USA and Canada ETL tested to UL508, UL-508-2010 CSA C22.2 #14-2010

Operation

• Status LED Modes - Red = Operation Mode, Blinking Green = Link Mode
• On-Levels - 0/100%
• During Power outage - Retains all settings in Non-volatile EERPOM

Mechanical

• Set Button - Button
• Wire Nuts - 4 included
• Mounting - Single Gang, 1/2" Knock out Stardard J Box, Surface or recessed mount module, mounts in fixture ballast compartment.
• Dimensions - Height: 2.8 in Width: 1.60 in Depth: 2.25 in
• Weight - 4.0 oz.
• Warranty - 5 years
• US Patent No. - 6,734,784; 6,784,790; 7,265,654; 7,688,183. U.S. and foreign patents may be pending.

Modes Descriptions

• Normal - Power Is applied to device
• Link - Press and Hold Rocker or Button for >6 sec.
• Link Exit - Tap while in Link Mode
• Test Mode - 5 taps while in NORMAL Mode of a Transmitter
• TEST Mode Exit - 1 tap while in TEST Mode
• Signal Strength Mode - 6 taps while in NORMAL Mode of a REceiver
• Noise Strength Mode - 7 taps while in NORMAL Mode of a Receiver
• Factory Default - 10 taps while in LINK Mode

Led Indicator Status

• Red - Normal Mode Power Applied
• Blinking Green - Link Mode
• Flashes Green - Transmitting
• Dark/Green - Test Mode
• Pulses Green 1-16X - Same Phase/ Signal Strength Display Mode of a Receiver
• Pulses Red 1-16X - Opposite Phase / Signal Strength Display Mode of a Receiver
• Pulses Orange 1- 16x - Relative Noise Strength at Receiver
• Blinks Red 10x - Indicates that device has been factory defaulted

SWX-FMR-AC Manual