FCM1R-120V GreenWorx Circuit Control Module 120V

The one channel GreenWorx Fixture Control Module is designed to control one full circuit with a load up to 20 A. Each FC1R contains one heavy-duty relay intended to control any fluorescent, LED, or induction lighting loads. Both 120V and 277V versions are available.

Specifications

Electrical

• Power Requirements - 120/277Volt AC, 50/60Hz: 3 Phase
• Connections/Power Wire - Terminal block, 12-14 AWG guage - solid or stranded, Black - Line, Red - Load, White - Neutral
• Standby Power Consumption - .5 Watt

Load Ratings

• Channels - 1
• Load per Channel - 20 amps @ 120 or 277 Volts AC, 50/60Hz
• Load Types - Flourescent, Inductive, LED
• Relay Life Cycle - 100,000 on/off operations at full electronic ballast load
• Connectors - 6 position Wago #253 series or equivalent
• Guage - 16-20 Solid or Stranded AWG

Operation

• Memory - Internal Flash, External EEPROM
• Status LED - SETUP mode = Blinks GREEN, TEST mode = Blinks ORANGE, Receiving Data = Blinks GREEN/RED, Transmitting Mode = Blinks RED, Lost or no Heartbeat = Slowly Blinks GREEN, Factory Default = Blinks RED rapidly

Environmental

• Operational Temperature - -40° to 194° F (-40° to 90° C)
• High Temperature models - -40° to 240° F (-40° to 115° C)
• Humidity - 10% to 90% RH (non-condensing)
• Heat Dissaipation - 5W
• Certifications - Safety tested for USA and Canada ETL tested to UL508

Mechanical

• Enclosure
• Mounting - Locate near Ballast
• Length - 4.90 in (125 mm)
• Width - 2.35 in (60 mm)
• Depth - 1.25 in (32 mm)
• Weight - 6.1 oz (173 g)