NQ-A2300-G2 Bogen Networked 2 Channel Audio Powered Gen 2 Amplifiers - 300W Per Channel @ 25V / 4Ohms

Bogen's Nyquist based networked audio power amplifiers offer cost-effective performance for permanent installations and commercial sound, and are designed to meet the rigorous requirements of today's sophisticated sound systems. Designed with the commercial sound contractor in mind, they provide unparalleled flexibility and versatility without the need for add-on modules. They offer state-ofthe-art, built-in DSP software for extensive and comprehensive signal processing, including preloaded Bogen NEAR loudspeaker presets, helping to optimize speaker performance and sound quality. Customers can also create and save their own speaker presets to fine tune the audio to their specific listening environments. These 2-channel amplifiers are available in 120, 240, and 600-watt models, each with the same features to provide power and performance, no matter how large or small the application. In addition to their extensive flexibility, the Nyquist Networked Power Amplifiers use the latest in Class D amplifier technology and provide unparalleled sonic quality, exceptional reliability, and reduced heat output for increased operating efficiency.

Specifications

• Power Output 2-Ch Mode (per Ch.) - 300W @ 25V/4 ohms
• Power Output 1-Ch Bridged Mode (per Ch.) - 600W @ 70V/25V/8 ohms
• Line-in Sensitivity (Gain min./max.) - Continuously variable from 2V to 0.1V RMS
• S/N Ration (20 kHZ BW) - 97 dB
• Power Output Bandwidth - 20 Hz- 20 kHz < .03% THD+N
• THD+N @ 1 kHZ rated power - < .03%
• Rated Load Impedance (min. per Ch.) - 8 ohms Bridged / 4 ohms Non-Bridged
• Frequency Response @ 1 Watt - 20 Hz - 20 kHz +/- 0.25 dB
• Class of Operation - Class D
• Connectors
  • Power - 10A Line Cord C14 IEC Inlet
  • Input - Balanced 3-pin Phoenix Plug/Header, Balanced 3-pin Neutrik XLR, RJ45, USB 2.0 Type A
  • Output - 4-pin "touch proof" Phoenix and 3-pin Neutrik XLR
• Line Inputs - 10k ohm electronically Balanced, 3-pin Phoenix and 3-pin Neutrik XLR
• AC Input Voltage Range - 85 VAC to 265 VAC 50/60 Hz
• Maximum AC Current - 6A
• Indicators - Status & Power LEDs (front)/Network LEDs (rear)
• Operating Temperature Range - -15 C to +40 C
• Thermal Emissions (Full Power) - 225 BTU/hr.
• Cooling - Convection
• Protection - RF, DC, Low Frequency, Thermal, Low Impedance, Short Circuit, Clip Limiting
• DSP Based Audio Features - 16-band Graphic Equalizer; Signal Present and Clip Monitor; Adjustable High Pass, Low Pass, and Bandpass Filters; Noise Gate; Compressor/Limiter: 7-band Parametric Equalizer
• Special Features - Sleep Mode (defeatable), Power Factor Correction (PFC), 89% Amplifier Efficiency. On/Off Muting, Bridge Mode Switch
• Networking - Cat5 or better 10/100 network connectivity to Bogen's Nyquist network
• Product Weight - 6.4 lbs.
• Physical Dimensions - 1/2 Rack Width x 2RU
• Single Rack Space (1RU) - 8.00" W x 1.70" H x 13.48" D
• Double Rack Space (2RU) - 8.00" W x 3.43" H x 13.48" D

NQ-A2300-G2 Specifications PDF